BackReceiver firmware update for Geode GNS2 and GNS1
1 Aug 2019
See original article below. Firmware version 1.2qq08t for the Hemisphere Crescent P206 GNSS OEM Board in our Geode GNS1 and GNS2 models is available at the following web link.
WARNING: Power must be maintained while firmware is being updated. Installing this firmware update is at your own risk. If desired, the firmware can alternatively be installed at a certified repair center.
Original article - 11 Dec 2018
Firmware updates are available from Hemisphere for the P206 receiver in the Geode, such as for enabling support for Galileo and Beidou. Older Geode units with the optional serial port can be updated in the field. Newer Geode units with later factory installed firmware can potentially be updated using the USB port. Otherwise a Geode would need to be submitted to our repair center for firmware update as instructed at the following web page.
Geode Connect may not be able to fully show when Multi-GNSS is enabled such as GLONASS, Galileo, Beidou, and others. The Terminal screen may need to be used to verify and configure these using commands from Hemisphere.
Version 1.2Qq06t or higher for USB with beta RightARM 3.48 or later from Hemisphere.
Older version 1.2Qm01t
